If you’ve recently picked up a Vaporesso, you might be wondering how to refill the cartridge properly — and more importantly, how to refill Vaporesso cartridges without spilling or damaging the pod. The good news is that Vaporesso devices are built for convenience, and the refill process is fast and simple once you get the hang of it.
How to Refill a Vaporesso Cartridge with E-liquid (Step-by-Step)
Start by removing the cartridge (pod) from your device — this works the same for most models like the Vaporesso XROS, XROS Mini, or Luxe series. Grip the pod gently and pull it upward. Once removed, you’ll notice the black mouthpiece on top. To access the fill port, you’ll need to pop this mouthpiece off — it usually clicks off with a slight push to the side.
Under the cap, you’ll see a small fill hole, typically located to one side. Be careful not to pour juice into the center airflow hole, as this can cause gurgling, spitting, or even coil flooding. Take your e-liquid bottle and slowly fill the pod through the side hole. Most Vaporesso pods hold around 2 ml of juice, so fill slowly and stop before reaching the very top.
Once filled, wipe off any excess liquid around the edges and snap the mouthpiece back in place firmly. Let the pod rest upright for about 5–10 minutes — this allows the coil to fully absorb the Chaser Salt E-Liquid, preventing dry hits or a burnt taste. This step is especially important if the pod or coil is brand new.
After priming, insert the pod back into your Vaporesso device until it clicks. Make sure it sits flush and that the device recognizes the cartridge — some devices will vibrate or flash an LED to indicate proper connection.
To get the best performance, avoid vaping when the pod is almost empty. Refill when you notice the juice level getting low, and always store your pod upright when not in use to prevent leaks or condensation buildup in the airflow.
By following this simple guide, you’ll keep your Vaporesso cartridge clean, leak-free, and working at its best for longer.
